#include "rev4.h" //#include "backlight.h" void matrix_init_kb(void) { // put your keyboard start-up code here // runs once when the firmware starts up matrix_init_user(); led_init_ports(); } void matrix_scan_kb(void) { matrix_scan_user(); } void backlight_init_ports(void) { print("init_backlight_pin()\n"); // Set our LED pins as output //DDRD |= (1<<6); // Esc //DDRB |= (1<<7); // Page Up //DDRD |= (1<<4); // Arrows // Set our LED pins low //PORTD &= ~(1<<6); // Esc //PORTB &= ~(1<<7); // Page Up //PORTD &= ~(1<<4); // Arrows } void backlight_set(uint8_t level) { /* if ( level == 0 ) { // Turn off light PORTD |= (1<<6); // Esc PORTB |= (1<<7); // Page Up PORTD |= (1<<4); // Arrows } else { // Turn on light PORTD &= ~(1<<6); // Esc PORTB &= ~(1<<7); // Page Up PORTD &= ~(1<<4); // Arrows } */ } void led_init_ports() { // Set our LED pins as output palSetPadMode(GPIOB, 13, PAL_MODE_OUTPUT_PUSHPULL); // LED1 palClearPad(GPIOB, 13); palSetPadMode(GPIOB, 14, PAL_MODE_OUTPUT_PUSHPULL); // LED2 palClearPad(GPIOB, 14); palSetPadMode(GPIOA, 8, PAL_MODE_OUTPUT_PUSHPULL); // LED3 palClearPad(GPIOA, 8); palSetPadMode(GPIOA, 0, PAL_MODE_OUTPUT_PUSHPULL); // Capslock LED palClearPad(GPIOA, 0); } void led_set_kb(uint8_t usb_led) { if (usb_led & (1<<USB_LED_NUM_LOCK)) { palSetPad(GPIOB, 13); // LED1 } else { palClearPad(GPIOB, 13); // LED1 } if (usb_led & (1<<USB_LED_CAPS_LOCK)) { palSetPad(GPIOA, 0); // Capslock LED palSetPad(GPIOB, 14); // LED2 } else { palClearPad(GPIOA, 0); // Capslock LED palClearPad(GPIOB, 14); // LED2 } if (usb_led & (1<<USB_LED_SCROLL_LOCK)) { palSetPad(GPIOA, 8); // LED3 } else { palClearPad(GPIOA, 8); // LED3 } }