# project specific files SRC = matrix.c \ led.c # GENERIC STM32F103C8T6 board - stm32duino bootloader OPT_DEFS = -DCORTEX_VTOR_INIT=0x2000 MCU_LDSCRIPT = STM32F103x8_stm32duino_bootloader BOARD = GENERIC_STM32_F103 # GENERIC STM32F103C8T6 board - no bootloader (programmer over serial or SWD) # OPT_DEFS = # MCU_LDSCRIPT = STM32F103x8 # BOARD = GENERIC_STM32_F103 # MAPLE MINI # OPT_DEFS = -DCORTEX_VTOR_INIT=0x5000 # MCU_LDSCRIPT = STM32F103xB_maplemini_bootloader # BOARD = MAPLEMINI_STM32_F103 ## chip/board settings # the next two should match the directories in # <chibios>/os/hal/ports/$(MCU_FAMILY)/$(MCU_SERIES) MCU_FAMILY = STM32 MCU_SERIES = STM32F1xx # linker script to use # it should exist either in <chibios>/os/common/ports/ARMCMx/compilers/GCC/ld/ # or <this_dir>/ld/ # startup code to use # is should exist in <chibios>/os/common/ports/ARMCMx/compilers/GCC/mk/ MCU_STARTUP = stm32f1xx # it should exist either in <chibios>/os/hal/boards/ # or <this_dir>/boards # Cortex version # Teensy LC is cortex-m0; Teensy 3.x are cortex-m4 MCU = cortex-m3 # ARM version, CORTEX-M0/M1 are 6, CORTEX-M3/M4/M7 are 7 ARMV = 7 # If you want to be able to jump to bootloader from firmware on STM32 MCUs, # set the correct BOOTLOADER_ADDRESS. Either set it here, or define it in # ./bootloader_defs.h or in ./boards/<FOO>/bootloader_defs.h (if you have # a custom board definition that you plan to reuse). # If you're not setting it here, leave it commented out. # It is chip dependent, the correct number can be looked up here (page 175): # http://www.st.com/web/en/resource/technical/document/application_note/CD00167594.pdf # This also requires a patch to chibios: # <tmk_dir>/tmk_core/tool/chibios/ch-bootloader-jump.patch #STM32_BOOTLOADER_ADDRESS = 0x1FFFC800 ifndef QUANTUM_DIR include ../../../Makefile endif